ACER KG 0766 DRIVERS

Remove the four screw that secures the power supply to the chassis. Disconnect the LED cable. Pre-disassembly Procedure Pre-disassembly Procedure Before proceeding with the disassembly procedure, perform the steps listed below: More Specifications Pc health status Features. Error Symptom Executing software shutdown from Windows98 Start menu does not turn off the system.

Uploader: Taurisar
Date Added: 1 May 2013
File Size: 44.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29937
Price: Free* [*Free Regsitration Required]

Initializes data variables that are based on CMOS setup acer kg-0766. Jumpers with more Than one pin are numbered. Pull the drive out of the drive.

acer kg-0766 Storage Device Message Displayed B: Kg-076 may takes half and hours to create RAID1. Page Step 5: Reload software from Recovery CD. Several acer kg-0766 are tested during POST, but is for the most part transparent to the user. Select two HDDs in “Disk” by space key. Removing the Mainboard Remove the eight screws that secure the mainboard to the chassis.

Release four screws according to the following picture. Revision History Please refer to the table below for the updates made on this service guide. No system power, acer kg-0766 power supply fan is not running.

Shut down the system,then add another two serial ATA hard drives in the system. System Time Set the system time following the hour-minute-second format.

User Password Indicates the status of the user password. Lift the heat sink fan assembly away from the mainboard. Option Enabled Acerr Chapter Lift the power supply acer kg-0766 out of the acer kg-0766.

ACER ASPIRE M SERVICE MANUAL Pdf Download.

To diagnose a problem, first find the error symptom in the left column. If the jumpers, acer kg-0766 and voltage settings are correct, ,g-0766 or disconnect the following, one at a time: It may takes half and hours to create RAID0.

Block Diagram Block Diagram Chapter acer kg-0766 After create completely,it will ask to reboot to finish create RAID0. Product Information The Product Information menu displays basic information about the system.

Acer Aspire M5811 Service Manual

Don’t have an account? Press “next” to finish setup and start create RAID5.

Release the acer kg-0766 lever 1. If the jumpers, switches and voltage settings are correct, remove or disconnect acer kg-0766 following, one at a time: Removing the Mode Card Gently pull the Mode card to remove it from the mainboard.

This may be due to a bad cable or caer diskette drive. Disconnect the power cables from the VGA card.

After create completely,it will ask to reboot to finish create RAID One finger Press the clip acer kg-0766 the same time Gently pull the card to remove it from the mainboard. Acer kg-0766 the power supply module out of the chassis. A acrr jitter can introduce a temporary boost in clock speed causing the overclocked processor to lock up.

Rate this post